GM-D8704 4-Channel Amplifier

Product Code: GM-D8704
RM1,499.00

From RM249.83/month

GM-D8704 4-Channel Amplifier

GM-D8704 4-channel amplifier will greatly improve the sound quality in your vehicle. This amplifier will power your front and rear speakers with 100 watts RMS each. You will hear much more of the little details in your music, especially when you turn your system up to overcome road noise. With this amplifier, you can run your front speakers with the front channels (A), then combine the rear channels (B) to drive a subwoofer. You can also put this versatile amp into 2-channel mode to send up to 300 watts RMS each to a couple of component speakers or subwoofers. The front channels have a variable high-and low-pass filters to adjust the sound for front sound staging or a finely tuned bass. Switchable high and low pass filters on the rear channels to enhance the full-range speakers. Speaker-level inputs allow you to add this amplifier to a factory system. This Class D amplifier is CEA-2006 compliant.

High Quality Sound Parts and Tuning

Audio film capacitors and low-impedance coil are used for the output LC filter to ensure excellent sound quality. Audio tuning based on the reproduction of the original audio source allows everyone to experience the difference in sound quality when connected.

High-capacity Audio Power Source Capacitor

Pioneer's original high-capacity audio power source capacitor contributes to higher sound quality and stable power allotment even at high output.

Variable HPF & LPF

Adjust LPF & HPF (40-500 Hz).

Bass Boost Remote

Bass Boost (Remote) for optimal bass level adjustment according to listening preferences and music characteristics.

Automatic Signal Sensing and Turn-On

Pioneer's Class-D amplifier automatically selects an input signal mode between the RCA level and the speaker level detecting an input signal. In the case of speaker line input, the amplifier will automatically switch on when the receiver is turned on.

Protection Control System

Designed to bolster reliability, this system reduces the risk of damage due to an overly high input power, by sensing the internal temperature and moderating the signal on-the-fly.

Class FD Technology

Enjoy first class sound and powerful volume on a versatile system at half the size of other units.


What’s in the Box

  • 4-Channel Amplifier
  • Two 30-amp ATO fuses (installed)
  • Bass Boost Remote Control
  • Bass Boost Remote Control Cable
  • 2 Speaker Level to RCA Input Adapters
  • Installation Screws X 4
  • Wire Terminal Tool
  • Owner's manual (English/ French)
  • 1 Year Warranty Sheet
Amplifier
Allowable Load Impedance 1 ohm to 8 ohm allowable
Avg Current Consumption (amps x #ch) 3.1 A x 4-Channel - 4 Ohm / 4.4 A x 4-Channel - 2 Ohm / 4.4 A x 2-Channel - 4 Ohm Bridged
Bass Boost 50 Hz - Frequency
Bass Boost Remote Yes
Bridgable Yes
CEA-2006 Compliant Yes
Class D
Continuous-Power-Output 100 W x 4-Channel - 4 Ohm / 125 W x 4-Channel - 1 Ohm / 150 W x 4-Channel - 2 Ohm / 300 W x 2-Channel - 4 Ohm Bridged
Crossover Network Channel LPF - A/B Ch 40Hz-500Hz / HPF - A/B Ch 40Hz-500Hz
Crossover Network Channel Slope -12db/oct (A/B Ch)
Frequency Response Channel 10 Hz - 50 kHz (+0dB,-3dB) A/B Ch
Fuse Rating 30 A x 2
Grounding System Negative
Hi-Res Certified Yes
Maximum Power Output 200 W x 4-Channel (4 Ohm) / 600 W x 2-Channel (4 Ohm Bridged)
Power Source 14.4V (10.8 V to 15.1 V allowable)
Protection Control system Yes
RCA Input 4-Channel
Signal to Noise 75 dBA (Reference: 1 W into 4 ohm)
Speaker Line input Sensor Yes
Terminal Type Block
THD-A/B/C Channel =/< 1% ( 20 Hz to 20kHz) A/B Ch
Unit Weight 5.5 lbs

Write a review

Name:
  Rating Bad           Good

Review
Note: HTML is not translated!